16 Operating the System
AS7200 User Manual - OPEX Corporation
While no suggestions can guarantee completely against work-related injuries,
you will certainly increase your comfort and safety while operating the AS7200
if you put these suggestions into practice. The scanner has been designed with
you in mind. If it is operated correctly, you should find your work experience
comfortable and enjoyable.
Main controls and system components
The list below describes many of the controls and components of the AS7200
system. Refer to Figure 1 on page 17.
Sort bins Scanned documents are sorted into one of six selectable output
bins.
Override feed control button The override feed control button allows you to
disable the ultrasonic multifeed detector when you are scanning thicker pieces,
such as certain envelopes that would not fit the profile of a regular envelope.
Audit trail printers The audit trail printers are located behind the sort bins.
Audit trails can be applied to the front and/or back of each scanned document.
Main power switch The main power switch is located on the electrical box
under the stacker bins as shown in Figure 1. This is the main “on/off” switch for
the AS7200 system. For more info on turning the AS7200 system on and off,
see page 18.
UPS (Uninterrupted Power Supply) The APC UPS provides backup battery
power to the AS7200 PC to complete transactions or save work should the
site’s AC power supply be interrupted.
Touchscreen monitor Use the monitor to log in and out of the AS7200
system. The monitor’s touchscreen controls should be used to operate the
system and run jobs.
Conveyor Place documents onto the drop feeder for scanning into the
AS7200 system.
Keyboard/mouse Typically, the keyboard and mouse are only used for
setting up jobs and for use with other software. Use the touchscreen monitor
for running jobs and operating the machine.
To Next Page
Loading...
