56 Operational Maintenance
AS7200 User Manual - OPEX Corporation
Removing/Replacing the Printer Cartridge
The scanner’s imprinter and HP ink cartridge are accessible when the transport
area is open. When you remove a cartridge, pay close attention to the position
and orientation of the cartridge so it can be replaced properly.
When you install a new printer cartridge, first check the expiration date of the
new cartridge you plan to use. The AS7200 printer cartridges in sealed
containers have a shelf life of two years from the date of manufacture.
To remove/replace a printer cartridge:
1 Pull the tab on the rear of the printer cartridge and rotate outward, as shown
in the figure below.
2 Remove the cartridge.
3 Insert the new cartridge by tipping the front end of the cartridge in first, and
then pushing in the rear of the cartridge until it “clicks” into place.
Adjusting the Printer Carriage Position
You can adjust the vertical print position on documents by moving the printer
carriage. The printer carriage is fixed to a shaft with detents that position the
printer so it sprays ink through the holes in the paper guide. A thumb screw
holds the printer in the detents. If you do not position the printer in a detent, the
thumb screw sticks out, preventing you from closing the paper guide.
Rear view of
printer carriage
To Next Page
Loading...
