Opex AS7200 - Page 77

Statistics 77
AS7200 User Manual - OPEX Corporation use only - not for distribution
Out Of Bounds
Sensor Blocked
The Out Of Bounds Sensor is blocked.
Out of Bounds
Detected
A piece is too tall for the imager.
Justification
Sensor Blocked
The Justification Sensor is blocked.
Feed Singulation
Defeat Button
Stuck
The override feed control button is stuck in a down
position.
Skew 9 Sensor
Blocked
The Skew 9 Sensor is blocked.
Skew 8 Sensor
Blocked
The Skew 8 Sensor is blocked.
Skew 7 Sensor
Blocked
The Skew 7 Sensor is blocked.
Skew 6 Sensor
Blocked
The Skew 6 Sensor is blocked.
Skew 5 Sensor
Blocked
The Skew 5 Sensor is blocked.
Skew 4 Sensor
Blocked
The Skew 4 Sensor is blocked.
Post Feed MFD
Trail Sensor
Blocked
The Post Feed MFD Trail Sensor is blocked.
Stepper Stall
Detected
A Stepper Motor has stalled.
Pre Crush Roller
Sensor Blocked
The Pre Crush Roller Sensor is blocked.
Feed Entry RX
Present Sensor
Blocked
The Feed Entry RX Present Sensor is blocked.
Table 6: Reasons for jams (continued)