Operating the System 45
DS2200 User Manual - OPEX Corporation use only - not for distribution
When the feeder detects a stack of paper of 6 or more pieces (depending on
the thickness of the paper), the conveyor will stop to allow for the stack to pass
through and will continue when the entire stack is fed. You can place more
stacks on the conveyor when it stops, but keep in mind that the conveyor will
only stop when the feeder encounters a stack of 6 or more pieces.
Make sure the second stack
has enough pieces to stop the conveyor, or the third stack
will run into the second and cause misfeeds and/or jams.
To Next Page
Loading...
