12
English
Installation
Powering On the Projector
1. Remove the lens cap.
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will turn green.
3. Turn on the lamp by pressing “ ” button on the control
panel. And the Power LED will turn blue.
4. Turn on your source (computer, notebook, video player,etc.).
The projector will detect your source automatically within
“Management-II” menu, check that “Source Detect” has
been set to “Auto”.
If the screen displays “No Signal”, please make sure the
signal cables are securely connected.
If you connect multiple sources at the same time, use the
“Source” button on the control panel or use the “Auto
Search”button on the remote control to switch.
Powering On/Off the Projector
Turn on the projector
first and then the signal
sources.
Power/Standby
Lens Cap
1
2
To Next Page
Loading...
