13
English
Installation
Warning Indicator
When the “LAMP” indicator lights solid red, the projector
will automatically shut itself down. Please contact your local
reseller or service centre. See page 40.
When the “TEMP” indicator lights solid red, it indicates the
projector has overheated. The projector will automatically
shut itself down.
Under normal conditions, the projector can be switched on
again after it has cooled down. If the problem persists, you
should contact your local dealer or our service center. See
page 40.
When the “TEMP” and “LAMP” indicator light solid red, it
indicates the fan has failed. Please contact your local dealer
or our service centre. See page 40.
Powering Off the Projector
1. Press the “ ” button to turn off the projector lamp, you will
see a message
displayed on the projector’s screen. Press the “Power/Stand-
by” button again to confirm, otherwise the message will
disappear after 5 seconds.
2. The cooling fans continue to operate for about 60 seconds
for cooling cycle and the Power LED will flash (1 second
intervals) green. When the Power LED begins flashing (0.5
second intervals), the projector has entered standby mode.
3. Disconnect the power cord from the electrical outlet and the
projector.
4. Do not turn on the projector immediately following a power
off procedure.
To Next Page
Loading...
