Optoma ES522 - Calibration Procedures; 6-1 Analog RGB Calibration

Delta Elec. Inc. ES522 & EX532
Company Confidential Optoma___________________ Delta________________
87
2009/06/30
6. Calibration
Step of into Service Mode
Step 1 : To turn on the projector, press the Power button on the keypad or IR controller,
.
Until the “Power Off? Press Power again” message appears.
Step 2：Then press “Left”=>“Right”=>“Down”=>“Up” button on the keypad or IR controller.
Step 3：If password is correct then go into Service Mode。