Optomed Smartscope PRO - Page 16

Page 16 of 51
Table below includes explanations of the Device settings tab:
Setting
Values (default bolded)
Purpose
Preview images
Ok
To preview the images on camera press middle button.
New patient folder
Ok
To create a new patient folder press middle button. New
patient folder can also be created in live view by long
pressing the middle key.
Erase image memory
Ok
Select middle button to erase images and videos from
camera SD card.
Edit patient list
Ok
Press middle key to edit patient list
Patient information
On/Off
Enable or disable patient information linking
Display brightness
Low-Med-High
Use left and right arrow keys to adjust display brightness
Icons
On/Off
Show graphical icons when imaging.
Sounds
On/Off
When enabled, sound is played during image capture
Keyboard backlight
On/Off
When enabled, keyboard illumination is on
Select language
ENG-FIN-FRA-GER-ITA-
JPN-POR-SPA-ZHO
Use left and right arrow keys to select camera language
USB write protection
On/Off
When enabled, writing to SD card is not allowed when
device is in cradle. This feature helps prevent any viruses
getting from PC to the camera. Note that if device contains
WLAN card, during its setup or updating of its firmware,
USB write protection need to be temporarily set off.
Video file format
MPEG4/MPEG1
Use left and right arrow keys to select video file format
Image transfer
method
UMS/WIA
Use WIA for automatic and UMS for end-user activated
image transfer. UMS can be used in most cases.
Restore factory
Setting
Ok
To restore all settings menus to factory defaults. Activate
using the middle key. Note that also Wireless password is
restored to default.
SD card firmware
update mode
Ok
To start SD card firmware update mode, press middle
button.
Date
DD-MM-YYYY
Use up and down arrow keys to set date.
Time
HH:MM
Use up and down arrow keys to set time.
Camera SW version
Show camera SW version
Browse version information with left and right arrow key
Start query
Era./Fol./None
Choose the startup query between memory erase, new
patient folder or no query at all.
Wireless
On/Off
Enable or disable wireless connection
Wireless info
Ok
To view ‘WLAN SSID’ and ‘WLAN Password’, press middle
button.
Preview images
Image preview is opened by selecting “Preview files” with a middle key. Images are browsed by using
arrow keys. Display gives information about usage of the image preview.
Image can be zoomed while previewing by pressing middle key. Move around the image by pressing arrow
keys. Change between the four zoom levels by pressing middle key.
Patient ID information can be edited in image browser.