Optronics PG11 - Table of Contents

Table of contents
1 Product Description and detection principle 5
1.1 Technical Specifications 6
1.2 Dimensions PG11 7
1.3 Dimensions PGE11 8
1.4 Detection principle of PG11 and PGE11 9
2 Safety and Warnings PG11 10
3 Installation 11
3.1 Installation checklist 11
3.2 Preparations and Positioning considerations 11
3.3 Mounting the detector 12
3.3.1 Pole mounting 13
3.3.2 Duct or pipe mounting 14
3.4 Electrical connections and Earthing 16
3.4.1 Booting up the Gas Detector 18
3.4.2 Performing loop test 18
3.5 Environment Shield for PG11 19
3.6 Sunshade 20
3.7 Mosquito net 21
4 Commissioning the Gas Detector 21
5 Operation 22
5.1 Function test 22
5.1.1 PG11 function check with the “Gas Test kit” 23
5.1.2 PG11 Function check with the “Gas Free Test kit” 24
5.1.3 PG11 Function check using the “Gas nozzle” 25
5.1.4 PG11 Function check with the “Remote Gas Test kit” 26
5.1.5 PGE11 short and medium Function check 27
5.2 Perform a check of the Gas Detector accuracy 28
6 Maintenance 29
6.1 Cleaning of optics - lens and mirror 29
6.2 Inspecting detector for damage 29
6.3 Keeping a stable Zeroing of the Detector 30
6.3.1 The OptoBAS™ function 30
6.3.2 Manual zero adjustment 30
6.4 Self Diagnostics 31
6.4.1 Downloading Self diagnostics datalog 31
6.5 The Blocking kit - Protection during site Maintenance 32
7 Signal outputs 33
7.1 Detector status flags 33
7.2 Light indicator 34
Document 022-80036-OM Revision R03 Page 3 of 48