Optronics PG11 - Accessories and Spare Parts

11 Accessories and Spare Parts
Below is an overview of accessories and spare parts for the PG11. Use the ordering number to
refer to these parts when in contact with the Supplier.
Ordering
number
Part
Description
ACC-ENV-STD
Environment Shield
To prevent water and other liquids from spraying
directly onto the optics
ACC-ENV-MOSQ
Mosquito net
Mesh fitted over the measuring section of the detector
to keep insects from blocking the Optics.
ACC-GT-BAS-KIT
Gas Test kit
To perform a quick gas test of the Safety Function of the
PG11 detector. Small container with gas connection that
is fitted on the outside of the detector nose, and
removed after the “Bump test” is finished.
ACC-GT-E15-KIT
PGE11 Short Gas Test
kit
To perform a quick gas test of the Safety Function of the
PGE11 15 cm detector. Small container with gas
connection that is fitted on the outside of the detector
nose, and removed after the “Bump test” is finished.
ACC-GT-E35-KIT
PGE11 Medium Gas
Test kit
To perform a quick gas test of the Safety Function of the
PGE11 35 cm detector. Small container with gas
connection that is fitted on the outside of the detector
nose, and removed after the “Bump test” is finished.
ACC-GT-REM-KIT
Remote Gas Test kit
For gas testing of detectors mounted high up or
another not easily reachable location. Kit consists of a
Gas nozzle on the nose of the detector and a “Gas test
box” to be mounted at a suitable location. When
performing Gas test the Operator connects the test Gas
cylinder to the “Gas test box”, and gas will pass from the
box in a gas pipe to the Gas nozzle and into the
detector.
ACC-GT-GF-KIT*
Gas Free Test kit
Kit to perform Gas testing without needing to use real
gas. Test of Safety function / Bump testing is done by
swapping the Environment Shield with the “Gas Test kit
Gas Free”. *Available in different variants.
ACC-GT-NOZ-KIT
Gas nozzle
Small accessory that is fixed to the front of the Gas
Detector. Used as a temporary or permanent set-upto
allow for gas to be injected straight into the sensor
section of the Detector.
ACC-GS-KIT
Gas Sampling kit
A flow cell attachment for incorporation with Gas
Sampling systems. Designed with minimum volume to
optimize for short response time. The Gas Sampling Kit
is also used to perform a precise calibration check.
ACC-CLEAN-KIT
Cleaning kit
For easier cleaning of the optics.
ACC-DF-KIT
Duct Flange kit
To mount the detector through wall type of
applications, typically a ventilation shaft.
Document 022-80036-OM Revision R03 Page 42 of 48