6.5 The Blocking kit - Protection during site Maintenance
Site Maintenance such as sand blasting and painting might damage the detector. To protect
the Detector during such work it is recommended to use the Blocking kit accessory. The
Blocking kit will fit into the Detector as illustrated below, protecting both the Optics and
Detector from pain, sandblasting and dirt. The Blocking kit will fit into the nose section and
will block the Optics forcing the detector into sending a Fault signal so the Detector is not
forgotten being covered with the Blocking kit.
Shown in the third image below is the protection bag that will fit over the housing. This
protection bag is packed inside the Blocking kit.
Document 022-80036-OM Revision R03 Page 32 of 48
To Next Page
Loading...