Oregon CHAINSAW - How to Install Chain Parts

SAW CHAIN
20.
SAW CHAIN
SAW CHAIN
HOW TO INSTALL NEW CHAIN PARTS
Read the warnings on page 12.
NOTE:
• Use only OREGON
®
parts to repair OREGON
®
chain. And only use
parts which are the correct size and type for your chain.
➊ Remove rivets, and parts to be replaced, as shown under “How to
Break Out Rivets," pages 22 to 23. Never reassemble a chain with
old preset tie straps - always use new preset tie straps.
➋ If needed, file off bottom of new parts to match existing worn parts.
File new cutters back to match worn cutters. Do not file the tops of
kickback-reducing bumper tie straps or bumper drive links.
➌ Place the preset tie strap on a flat
outer surface of a chain-breaker
anvil. Be sure the rivets are pointing
up.