Oregon CS250 - Oregon Chainsaw Assembly; Filling the Oil Reservoir

16
OREGON® PowerNow™ 40V MAX CHAINSAW
MODEL CS250 OPERATOR’S MANUAL
F/N 547361 RevAD
© 2011 Blount, Inc.
ASSEMBLY
UNPACKING
Somechainsawkitscomecompletely
assembled.Ifthechainsawhasbeen
packagedwithoutthesawchainand
guidebarinstalled,seeReplacingtheBar
andChaininthismanualforinstallation
instructions.Afterremovingthe
chainsawfromitsbox,inspectitcarefully
to make sure no damage has occurred
duringshipping.
Some chainsaw kits come with metal
buckingspikesasanaccessory.
Dependingonusertechnique,the
metalbuckingspikesmayincreasethe
stabilityofthechainsawduringfelling.
Themetalbuckingspikesmayreduce
thecutqualityduringpruning,again
dependingonusertechnique.
Inspectthechainsawformissingparts.
Ifanypartsaredamagedormissing,
contact OREGON® PowerNow™ to obtain
replacementparts.
DANGER: DO NOT ATTEMPT TO
OPERATE THE CHAINSAW IF ANY
PART IS DAMAGED OR MISSING.
Afterunpackingthechainsaw,check
thepositionofthehandguard.The
chainsaw will not run with the chain
brake engaged. Pull the hand guard
backtowardsthefronthandlebefore
operation(Fig.4).
Fig. 4
HAND GUARD IN
OPERATING POSITION
HAND GUARD IN
BRAKE POSITION
FILLING OIL RESERVOIR
Barandchainoilisrequiredto
properlylubricatethebarandchain.
UseOREGON®barandchainoilfor
bestresults.Itisspeciallydesignedto
providelowfrictionandfastercuts.
NEVER use oil or other lubricants not
specicallydesignedforuseonthebar
and chain. This can lead to a clogged
oilsystem,whichmaycausepremature
wearofthebarandchain.
Placethechainsawonitssideonarm,
atsurface,sothattheoilcapison
top(Fig.5).Aftercleaninganydebris
fromthecaparea,removethecapand
carefullypourthebarandchainoilinto
thereservoir.Filltothebottomofthe
llneck.Replacethecap,placethesaw
upright,andviewthelevelthroughthe
oilinspectionwindow.Oilshouldllthe
window.
CAUTION: CHECK OIL LEVEL
FREQUENTLY AND FILL AS NEEDED.
NEVER OPERATE THE CHAINSAW IF
OIL IS NOT VISIBLE.
Fig. 5
ASSEMBLY