Oregon CS250 - Oregon Chainsaw Battery Operations; Charging the Battery Pack; Inserting and Releasing Battery

18
OREGON® PowerNow™ 40V MAX CHAINSAW
MODEL CS250 OPERATOR’S MANUAL
F/N 547361 RevAD
© 2011 Blount, Inc.
OPERATING THE SAW
CHARGING THE BATTERY PACK
WARNING: FAILURE TO FOLLOW
PROPER CHARGING PROCEDURES
MAY CAUSE EXCESSIVE VOLTAGE,
EXCESSIVE CURRENT FLOW, LOSS
OF CONTROL DURING CHARGING,
LEAKAGE OF HAZARDOUS
CHEMICALS, HEAT GENERATION,
BURSTING, OR FIRE.
With the charger cord connected to the
chargerandpluggedintoanelectrical
outlet, align the grooves in the battery
with the rails on the charger and slide
thebatterypackontothechargeruntil
fullyseated(Fig.9).
Fig. 9
Checkthecharge-stateindicatorfor
charging conditions.
Thebatterypackshouldbeready
foruseinapproximatelyonehour
forS-seriesbatterypacksandin
approximatelytwohoursformodel
E-seriesbatterypacks.
INSERTING AND RELEASING
THE BATTERY PACK
Align the groove in the battery with the
railsinsidethebatteryport.Firmlyinsert
thebatterypackintothechainsaw’s
batteryport,pressingforwarduntilyou
hearaclickasitlocksintoplace(Fig.10).
Fig. 10
Toremovethebatterypack,liftupon
thebatteryreleaseandremovethepack
(Fig.11).
Fig. 11