Oregon CS250 User Manual

17
OREGON® PowerNow™ 40V MAX CHAINSAW
MODEL CS250 OPERATOR’S MANUAL
F/N 547361 RevAD © 2011 Blount, Inc.
OPERATING THE SAW
BATTERY PACK AND CHARGER
BATTERY PACK LED CHARGE-LEVEL
INDICATOR
Thelithiumionbatterypackisequipped
withanLEDcharge-levelindicator.Totest
thechargelevelofthebatterypack,press
theindicatorbuttononthebatterypack’s
face(Fig.6).
No lights: recharge.
One steady green light:
lessthan25%charged.CHARGE
BATTERYPACKBEFOREUSE.
Two steady green lights:
26-50%charged.
Three steady green lights:
51-75%charged.
Four steady green lights:
76-100%charged.
Fig. 6
INDICATOR LIGHTS
INDICATOR BUTTON
CONNECTING THE CHARGER
Connect the charger cord to the charger
andtotheproperelectricaloutlet
(Fig.7).
Fig. 7
Onlyusethecordsetthatwassupplied
withthecharger.Atrstuse,verifythat
theplugtypematchesthereceptacle.
CHARGER LED CHARGE-STATE
INDICATOR
Thebatterychargerisequippedwithan
LEDcharge-stateindicatorthatalerts
youtothestateofcharging,aswellas
conditionsthatmaydelayorprevent
charging(Fig.8).
Note:Untilabatterypackisinserted,no
lights will be visible.
Blinkingorangelight:afault
condition exists. There are
severalpotentialcauses.See
Troubleshooting in this manual.
Steady orange light: the battery
packtemperatureisbeyond
theacceptablerange(32°F/0°C
to104°F/40°C).ALLOWTHE
BATTERYPACKTOREACHTHE
ACCEPTABLE TEMPERATURE
RANGE BEFORE CHARGING. The
packmaybeleftonthecharger
AS THE TEMPERATURE ADJUSTS.
Charging will begin when the
propertemperatureisreached.
Fig. 8
Blinkinggreenlight:batterypack
is charging.
Steadygreenlight:batterypack
READY FOR USE.
OPERATING THE SAW

Oregon CS250 Specifications

General

Brand	Oregon
Model	CS250
Category	Chainsaw
Language	English