Oregon CS250 User Manual

19
OREGON® PowerNow™ 40V MAX CHAINSAW
MODEL CS250 OPERATOR’S MANUAL
F/N 547361 RevAD © 2011 Blount, Inc.
OPERATING THE SAW
GENERAL OPERATION
WARNING: ALWAYS WEAR PROPER
GLOVES AND HEARING AND EYE
PROTECTION.
PROPER GRIP
Withthesawonarm,atsurface,
graspthefronthandlewiththeleft
hand and the rear handle with the right.
Fingersshouldwrapoverthetopof
the handle and the thumb below the
handle(Fig.12).
GRIP WITH THUMB
BELOW HANDLE
Fig. 12
PROPER STANCE
Bothfeetshouldbeonsolidground,
withweightevenlyspreadbetween
them.
Leftarmshouldbestraight,withelbow
locked.Thishelpstowithstandthe
forcesgeneratedbykickback.
STOPPING THE SAW
Tostopthechainsaw,releasethetrigger
switchandthetriggerlock-out.
STARTING THE SAW
Graspthetopandrearhandlesrmly.
Pressandholdthetriggerlock-outwith
thethumb(1).Tostartthesaw,squeeze
thetriggerswitch(2)(Fig.13).Thereis
noneedtocontinuetopressthetrigger
lock-out.Itwillremaindisengageduntil
the trigger is released.
(1) TRIGGER LOCK-OUT
(2) TRIGGER
SWITCH
Fig. 13
CUTTING
BASIC CUTTING
WARNING: ALWAYS BE SURE OF
FOOTING AND HOLD THE CHAINSAW
FIRMLY WITH BOTH HANDS WHILE
THE MOTOR IS RUNNING.
Assumethepropercuttinggripand
stanceinfrontofthewoodwiththe
sawo.Pressthetriggerlock-outand
squeezethetriggerswitch.Letthe
chainreachfullspeedbeforebeginning
the cut.
Begincuttingbylightlypressingthe
guide bar against the wood. Use only
lightpressure,lettingthesawdothe
work.
Maintainasteadyspeedthroughoutthe
cut,releasingpressurejustbeforethe
endofthecut.

Oregon CS250 Specifications

General

Brand	Oregon
Model	CS250
Category	Chainsaw
Language	English