932502G / 0618 7. FIRMWARE COMMANDS AND RESPONSES
DISABLE_ZDT
Returns the DSPEC 50 to normal operation if in zero-dead-time (ZDT) mode. See
ENABLE_ZDT.
ENABLE_BLRE_AUTOMATIC
Enables the automatic determination of baseline restorer time constant. See also
DISABLE_BLRE_AUTO, SHOW_BLRE, and SET_BLRE.
ENABLE_ETP
Sets the DSPEC 50 to Enhanced Throughput (ETP) mode. See also DISABLE_ETP,
SHOW_ETP, SET_TIME_ETP, LIST_TIME_ETP, and SHOW_TIME_ETP.
ENABLE_FAST_COIN
Enables the Fast Coincidence function for use with Coincidence or AntiCoincidence gating.
ENABLE_GAIN_STABILIZATION
Enables the stabilization of the gain peak. See also DISABLE_GAIN_ STABILIZATION,
SHOW_GAIN_STABILIZATION, and INITIALIZE_GAIN_STABILIZATION.
ENABLE_HV
Turns on the high-voltage enable output of the DSPEC 50. See also DISABLE_HV and
SHOW_HV.
Non-USB Execution Errors:
%131137085<CR> The high voltage could not be enabled due to a high voltage
shutdown condition.
ENABLE_HV_DIM
Enables the DSPEC 50 to work with a standard DIM (e.g. DIM-POSNAI, DIM-POSGE, or
DIM-NEGGE, DIM-296). This command enables the DSPEC 50 to poll the DIM and causes
the DSPEC 50 to return SOH information to a controlling program (see
SHOW_HV_HEALTH command).
ENABLE_LFR
Sets the DSPEC 50 to LFR mode. See also DISABLE_LFR and SHOW_LFR.
ENABLE_NAI
Switches the stabilizers to NaI mode. The stabilizers use the “fine” adjustment in NaI
mode and the “very fine” adjustment in Ge mode. See DISABLE_NAI.
85
To Next Page
Loading...
