25
REV. 02 - Cod.: 1500161
Operation and maintenance manual / Ed. 06 - 2007
THERMO-SEALING MACHINE FOR TRAYS
EN
EN
7.2 PROGRAMMED MAINTENANCE
Power cable.
Tray holder silicone seal (A) and “T” profile
for film cutting (B).
Sealing plate (C).
Machine.
Tray holder carriage (D) (mod. LST and PROFI-
1).
Before each start up
Periodically.
Check to make sure it is intact, replace if
damaged (Contact a specialist Service Centre).
Check to make sure these are inserted correctly
in their seats; replace if defective.
Check to make sure it is clean and free of
impurities and encrustations.
Clean to remove impurities, oil and grease.
Clean the carriage runner guides(E) with a
clean damp cloth.
FREQUENCY MACHINE PART ACTION
A
C
B
E
D
•
•
•
•
•
MAINTENANCE
7. MAINTENANCE
7.1 GENERAL WARNINGS
ELECTRIC HAZARD!
Maintenance and/or repair operations on any of the appliance components must be done only after disconnecting the power
supplies (Disconnecting the plug from the mains).
ATTENTION!
Only qualified personnel must be allowed to carry out maintenance operations or access powered parts of the machine.
ELECTRIC HAZARD!
Disconnect the electric current before carrying out cleaning or maintenance.
For repairs, if necessary, contact a Service Centre authorized by the manufacturer. Use and demand genuine spare parts.
To Next Page
Loading...
