21
REV. 02 - Cod.: 1500161
Operation and maintenance manual / Ed. 06 - 2007
THERMO-SEALING MACHINE FOR TRAYS
EN
EN
GENERAL INFORMATION
3. PRELIMINARY INFORMATION
3.1 TECHNICAL DATA
2.4.2.6 MODIFYING THE APPLIANCE
DANGER!
- Do not make any modifications or changes on the machine without the manufacturer’s permission.
- Replace all deteriorated, worn or damaged parts immediately (replacement must be done by a qualified technician).
- Use only genuine spare parts.
2.4.2.7 FIRE PREVENTION
DANGER!
- Guarantee the right ventilation of the machine with a distance from surrounding parts at least 10 cm.
- Do not place the machine near inflammable products.
DANGER! Danger of burns: if alcohol-based or inflammable products are used for disinfecting, air the area. Do not use
naked flames near the machine! Do not smoke!
2.4.2.8 CLEANING AND DISMANTLING THE MACHINE
ATTENTION!
- Clean the machine regularly by following the instructions given in this Manual.
Use and handle cleaning products according to the manufacturer’s instructions.
- Scrapping and disposal of the machine, parts and products used for cleaning the machine must be done strictly
in compliance with the applicable standards.
2.4.2.9 HAZARDS DERIVING FROM PNEUMATIC SPRINGS FITTED ON THE SEALING HEAD
DANGER!
- Never open the pneumatic springs, as the pressure inside them is extremely high(about 180 bar).
- Before scrapping the machine, discharge the pneumatic springs. Request instructions for disposal.
A
B
H1
H2
PROFI 1
A
B
H2
PROFI 2
H1
A
B
LST
H2
H1
PROFI 3
A
B
H2
H1
To Next Page
Loading...
