䡵 Tighten three knurled bolts.
Please note: After startup, the OTT Pluvio
2
S uses a 2 minute delay to output the
measured values. During this period, the precipitation values are identified in the
status information as not completely available yet.
Pipe housing
Knurled bolt
(3 x)
Fig. 20: Fitting the pipe housing and
tightening the knurled screws.
Please note: Always place and remove
the pipe housing of the OTT Pluvio
2
S with
orifice rim heater straightly!
28
To Next Page
Loading...
