1 Scope of supply
䊳
OTT Pluvio
2
S – Weighing precipitation gauge;
collecting area: 200 cm
2
; capacity: 400 mm of precipitation.
Consisting of: base plate with weighing mechanism, bucket support,
collecting bucket, and pipe housing. With SDI-12, RS-485, and USB
interfaces (for servicing purposes). Additional pulse outputs for amount
of precipitation and status information.
Optionally available with additional internal orifice rim heater.
– Installation accessory kit
(6 hexagon bolts M 8 x 30;
3 Phillips screws M 5 x 35
1 8-wire screw terminal strip;
1 6-wire screw terminal strip;
3 cable ties 140 x 3.6;
1 Jumper
1 open-ended wrench, size: 10/13
– USB cable
U
SB connector type A to USB connector type B, 3 m
– Operating Instructions
– Factory acceptance test (FAT) certificate
2 Order numbers
䊳
OTT Pluvio
2
S 70.030.002.9.0
䊳
OTT Pluvio
2
S incl. internal orifice ring heater 70.030.001.9.0
For accessories and replacement parts, refer to Appendix E
4
To Next Page
Loading...
