Ouster OS1 - Page 56

Table 20.1– continuedfrompreviouspage
ID Category Level Alert Message
0x01000005 OVERTEMP ERROR Unitinternaltemperaturetoohigh; pleasesee
userguide for heatsinkingrequirements.
0x01000006 OVERTEMP ERROR Unitinternaltemperaturetoohigh;pleasesee
userguide for heatsinkingrequirements.
0x01000007 UNDERTEMP ERROR Unit internal temperature too low; please see
userguide for heatsinkingrequirements.
0x01000008 OVERTEMP ERROR Unitinternaltemperaturetoohigh;pleasesee
userguide for heatsinkingrequirements.
0x01000009 OVERTEMP ERROR Unitinternaltemperaturetoohigh;pleasesee
userguide for heatsinkingrequirements.
0x0100000A OVERTEMP ERROR Unitinternaltemperaturetoohigh;pleasesee
userguide for heatsinkingrequirements.
0x0100000B OVERTEMP ERROR Unitinternaltemperaturetoohigh;pleasesee
userguide for heatsinkingrequirements.
0x0100000C INTERNAL_COMM ERROR Unithas experiencedan internalCOMMerror;
pleasecontactOusterathttps://ouster.com/
tech-support.
0x0100000D INTERNAL_COMM ERROR Unithasexperienced aninternalCOMM error;
pleasecontactOusterathttps://ouster.com/
tech-support.
0x0100000E SHOT_LIMITING NOTICE Temperature ishighenough whereshot limit-
ingmaybeengaged;pleaseseeuserguidefor
heatsinking requirements.
0x0100000F SHOT_LIMITING WARNING Shot limiting mode is active. Laser power is
partiallyattenuated;pleaseseeuserguidefor
heatsinking requirements.
0x01000010 INTERNAL_FW ERROR Unit has experienced an internal er-
ror; please contact Ouster at https:
//ouster.com/tech-support.
0x01000011 ETHERNET_LINK_BAD WARNING Ethernet link bad, please check network
switch and harnessing can support 1 Gbps
Ethernet.
0x01000012 INTERNAL_COMM WARNING UnithasexperiencedaninternalCOMMwarn-
ing: some measurements may have been
skipped.
0x01000013 INTERNAL_COMM WARNING UnithasexperiencedaninternalCOMMwarn-
ing: some measurements may have been
skipped.
continueson nextpage
56