Error 1: Overvoltage
The message "Err 1" indicates that the voltage has reached 70 Volts. An overvoltage may cause damage to the
electronic power devices as well as to the batteries. The drive is disabled immediately and the scooter stops (despite
stili being powered). The user can try to resume riding by switching the scooter off and then switching it back on.
Even when the rider manages to make the "Err 1" message disappear with this procedure and hence resume riding, it
is advisable to take the vehicle to a service centre as soon as possible and report the fault encountered. If. once the
scooter has been switched on again (after a few seconds), the "Err 1" message reappears, the scooter must be
switched off and taken to a service centre.
Error 2: Undervoltage
The message "Err 2" indicates that the voltage has dropped below 20 Volts. An undervoltage may cause damage to
the electronic devices. The drive is disabled immediately and the scooter stops (despite stili being powered). The user
can try to resume riding by switching the scooter off (by turning the mechanical key to OFF) and then switching it back
on (by turning the mechanical key to ON). Even when the rider manages to make the "Err 2" message disappear with
this procedure and hence resume riding, it is advisable to take the vehicle to a service centre as soon as possible and
report the fault encountered.
If, once the scooter has been switched on again (after a few seconds), the "Err 2" message reappears, the scooter
must be switched off and taken to a service centre.
Error 5: Engine overtemperature
Indicates that the engine temperature has exceeded 140°C or is lower than -25°C.
To Next Page
Loading...