An overtemperature may be the result of a mechanical problem (e.g. damaged bearings) or electric/electronic
problems (deriving from an incorrect engine check, for example).
The overtemperature may cause damage to the engine (overheating/burnt winding/demagnetization of magnets etc.).
The drive is disabled immediately and the scooter stops (despite stili being powered). The user can only try to resume
riding, by switching the scooter of f and then switching it back on, once the engine case has cooled down.
Should this procedure not make the "Err 5" message disappear and enable the user to resume riding, the scooter
must be switched off and taken to a service centre.
Error 7: Current alarm
Indicates an anomaly in the current circuit. The drive is disabled immediately and the scooter stops (despite stilI being
powered). The user can try to resume riding by switching the scooter off and then switching it back on.
Even when the rider manages to make the "Err 7" message disappear with this procedure and hence resume riding, it
is advisable to take the vehicle to a service centre as soon as possible and report the fault encountered. If, once the
scooter has been switched on again (after a few seconds), the "Err 7" message reappears, the scooter must be
switched off and taken to a service centre.
Error 10 : Battery charger alarm
Indicates an anomaly in the current circuit. The drive disabled immediately and the scooter stops (despite still being
powered). The user can try to resume riding by switching the scooter off and then switching it back on.
To Next Page
Loading...