Need help?Do you have a question about the PAC R6000S and is the answer not in the manual?
General| Brand | PAC |
|---|---|
| Model | R6000S |
| Category | Measuring Instruments |
| Language | English |
Details the terms and conditions of the limited warranty for the product.
Covers use of third-party parts, consumables, and voids warranty.
Lists conditions and circumstances not covered by the warranty.
Procedures for returning products for warranty or out-of-warranty service.
Process for determining product warranty status after examination.
Policy for field service representatives when remote repair is not possible.
Critical hazard warnings indicating potential death or serious injury.
Warnings about potential minor or moderate injury from chemical hazards.
General safety, usage, and compliance statements for the equipment.
Guidelines for the correct and safe installation, operation, and maintenance.
Defines the intended normal use of the R6000S analyzer.
Lists essential tools required for maintenance procedures.
Specifies who should read and understand the manual's content.
Explains the R6000S analyzer's working principles and detection process.
Lists the technical specifications of the R6000S analyzer.
Describes the components used in the analyzers.
Details the controls and indicators on the R6000S Analyzer.
Describes the controls on the front of the detector module.
Details the connections and ports on the back of the detector module.
Describes the components and controls of the furnace module.
Describes common trouble alarms and their visual indicators.
Details power, environmental, and gas requirements before installation.
Step-by-step guide for installing the instrument and its components.
Instructions for installing compression fittings for gas lines.
Steps for connecting gas lines to the furnace and detector modules.
Instructions for connecting signal output and power cords.
Procedures for installing the pyrotube into the furnace.
Step-by-step guide for powering up and initializing the R6000S analyzer.
Procedures for calibrating the analyzer using zero and span gases.
Steps to set the zero calibration for the analyzer.
Steps to set the span calibration for the analyzer.
How to return the analyzer to normal operating mode.
Procedures for adjusting temperature controller parameters.
Steps to adjust the full-scale range of the analyzer.
Guidelines for regular care to keep the system operating at peak level.
Schedule for component replacement based on average lifespan.
Procedures for removing and replacing major subassemblies.
Detailed steps for removing and replacing the sulfur detector module.
Procedure for replacing the PMT in the sulfur or nitrogen detector.
Steps for replacing the pre-amplifier assembly of the detector.
Procedures for servicing or replacing the fluorescence chamber assembly.
Steps to null the UV lamp after servicing or moving it.
Instructions for replacing the UV lamp in the sulfur detector.
Steps for removing and replacing the UV/PMT power supply assembly.
Procedure for replacing the detector's thermoelectric cooler.
Steps for replacing a detector temperature sensor.
Procedure to follow if a gas leak in the flow system is suspected.
Steps to isolate and repair light leaks in the detector system.
Instructions for cleaning lenses within the fluorescence chamber.
Procedure to adjust the PMT High-Voltage module.
Guide to help isolate and correct operating problems with the analyzer.
Steps for replacing electrical or electronic components in the system.
A guide to diagnose and correct common symptoms and their probable causes.
Lists drawings referenced for maintenance and service of the analyzer.
To Next Page