PEC017
5/3/2018 Page 103 of 105
23.0 Troubleshooting Errors in PACCAR Vehicle Pro
When changing parameters in PACCAR Vehicle Pro, errors may occur when
paramters are configured outside of their intended ranges or if conflicts exist between
paramters. Programming rules are enforced when submitting new software
configurations, and error messages may appear. The following table is intended to
provide clarification of commonly encountered error messages and requirements to
resolve them:
N006~MUST~BE~GTE~N003~PLUS~5MPH
The Maximum Cruise Control Target Speed (N006) must be at least 5 MPH greater
than Minimum Cruise Control Target Speed (N003)
N055~MUST~BE~LESS~THAN~N056
Remote PTO Preset Engine Speed 1 (N055) must be less than Remote PTO Preset
Engine Speed 2 (N056)
N055~MUST~BE~WITHIN~N106~AND~N056
Remote PTO Preset Engine Speed 1 (N055) must be greater than or equal to PTO
Mode Minimum Engine Speed (N106), and also less than or equal to Remote PTO
Preset Engine Speed 2 (N056)
N056~MUST~BE~WITHIN~N055~AND~N086
Remote PTO Preset Engine Speed 2 (N056) must be greather than or equal to
Remote PTO Preset Engine Speed 1 (N055), and also less than or equal to
Maximum Engine Speed using Switch Inputs (N086)
N076~MUST~BE~GTE~MIN~PTO~ESPD~N106
Maximum Engine Speed using Pedal Input (N076) must be greater than or equal to
PTO Mode Minimum Engine Speed (N106)
N078~MUST~BE~DISABLED~IF~N079~~~EQ~~~0
Disable PTO Mode w/Clutch Depressed (N079) must be disabled if Require Parking
Brake for PTO Mode (N079) is disabled
N079~MUST~BE~DISABLED~FOR~MOBILE~PTO
Require Parking Brake for PTO Mode (N079) must be disabled for Mobile PTO
control type selections
N079~MUST~BE~ENABLED~FOR~REMOTE~PTO
Require Parking Brake for PTO Mode (N079) must be enabled for Remote PTO
control type selections
N079~MUST~BE~ENABLED~FOR~STATIONARY~PTO
Require Parking Brake for PTO Mode (N079) must be enabled for Stationary PTO
control type selections
To Next Page
Loading...
Need help?
General
