DASH-MOUNTED FEATURES PART 4: CONTROLS AND DISPLAYS
– 56 – Y53-6032 (R05/10)
• A rocker switch (E) on the lower center portion to send
power to the “bunk” or sleeper control panel.
• A rocker switch (F) in the lower right portion to select
either fresh or recirculated air mode.
The sleeper control panel will have two controls (see next
illustration):
• A rotary knob in the left portion controlling the blower
speed with four settings.
• A rotary knob in the right portion controlling the air
temperature.
The cab “bunk” control rocker switch must be ON for the
sleeper controls to function.
• To heat the cab, select the desired air mode and set
the temperature knob to hot (the red position on the
control) and the blower to whatever speed makes you
most comfortable.
WARNING! Do not drive with visibility reduced
by fog, condensation, or frost on the wind-
shield. Your view may be obscured, which
could result in an accident involving causing
death or personal injury. For clear visibility
02980B
4
A
B
C
D
E
F
3
2
1
02981B
4
3
2
1
Y53-6032.book Page 56 Monday, May 24, 2010 3:37 PM
To Next Page
Loading...
