PART 4: CONTROLS AND DISPLAYS STEERING COLUMN-MOUNTED CONTROLS
(R05/10) Y53-6032 – 37 –
Windshield Wipers/Washer
Your vehicle is equipped with a two-speed, intermittent
windshield wiper system. A seven-position rotary wiper
switch (located on the turn signal lever) operates the wind-
shield wipers and washer (see next illustration). Rotate
the end of the turn signal lever to change the wiper mode.
NOTE:
The ignition key must be turned to ON or
ACC for the wiper/washer switches to operate.
The first position after OFF is the intermittent #1 cycle.
The next positions are intermittent #2, #3, and #4. The last
two positions are wiper low speed and wiper high speed.
See the wiper switch settings table that follows for inter-
mittent delay times.
To Wash The Windshield
Push the rotary wash/wipe knob in (towards steering col-
umn), hold for more than 0.8 seconds and then release.
Hold the knob in to extend the washing cycle. After the
Wiper Switch Settings
Wiper Switch Position Wiper Speed
Off Off
Intermittent #1 20 Second Delay
Intermittent #2 17 Second Delay
Intermittent #3 7 Second Delay
Intermittent #4 4 Second Delay
Low Low Speed
High High Speed
Y53-6032.book Page 37 Monday, May 24, 2010 3:37 PM
To Next Page
Loading...
