Pace ST 115 - LED Display Accuracy; LED Display Message Codes

32
Repair
LED Display Accuracy
No adjustments are necessary to maintain the accuracy of the system.
LED Display Message Codes
Following LED Display message codes which may appear if a mistake is made by the
operator (e.g., wrong Password entry) or if the system has malfunctioned.
LED Display Message Description
The incorrect Password has been entered. The displayed
message will time out after 6 seconds and revert to
normal operation. Enter the correct Password.
The LED Display is
flashing.
No handpiece is connected to the Power Receptacle.
Connect handpiece.
The handpiece heater assembly sensor is open. Refer
to Table 4 to check handpiece.
The LED Display is
flashing.
The handpiece heater assembly sensor is shorted.
Refer to Table 4 to check handpiece.
The LED Display is
flashing.
The handpiece heater assembly may be defective.
Refer to Table 4 to check handpiece.
Power source malfunction. Call the PACE Service
Department for assistance.
Tel. 1-888-535-7223 (toll-free), FAX 1-301-483-7030.
Table 2. LED Display Message Codes