Pacmac 2015 - SERVO SETUP; FILM DRIVE SETUP; JAW DRIVE SETUP

2015OPERATIONSMANUAL

27

SERVO SETUP
THE SERVO SETUP SCREEN IS USED TO CHANGE
CONFIGURATIONS FOR THE SERVO CONTROLLERS.
FILM DRIVE
 OUTPUT 4 ENABLE:
o ENABLES OUTPUT 4 OF SERVO CONTROLLER TO RUN A
PRINTER.
 OUTPUT 4 DELAY TO START:
o MILLISECOND DELAY TO START
 OUTPUT 4 ON DURATION:
o MILLISECOND ON DURATION LATCH
JAW DRIVE
 JAW OPENING
o CHANGES HOW FAR THE JAW OPENS
 JAW CLOSE OFFSET
o CHANGES HOW FAR THE JAW CLOSES.
 JAW MOTOR LOCATION
o CONFIGURES THE COMPUTER FOR FRONT OR REAR
MOUNTED JAW SERVOS.
 STAGE OPENING.
o CHANGES HOW FAR THE JAW STAGE OPENS.