Pacmac 2015 - PM SCHEDULE; DAILY MAINTENANCE TASKS; WEEKLY MAINTENANCE TASKS; MONTHLY MAINTENANCE TASKS

2015OPERATIONSMANUAL

66

PM SCHEDULE
 DAILY
o
CHANGE HORIZONTAL HEATER BAR TAPE
o
CLEAN THE KNIFE BLADE GROOVES
o
CLEAN THE KNIFE BLADE
o
CHECK WIRE CONNECTIONS
o
CHANGE GRIPPER CORDS
 WEEKLY
o
CHANGE VERTICAL HEATER BAR TAPE
o
GREASE ALL GREASE ZERKS WIPING OFF EXCESS GREASE
o
REPLACE 2” WIDE TAPE ON TUBE IF APPLICABLE
o
CLEAN NIP AND DRIVE ROLLER
o
CLEAN PULL BELTS
o
TEST ALL ASSEMBLIES FOR PROPER FUNCTION AND AIR
LEAKS
o
CHECK JAW MAYME LEVER BEARINGS FOR SLACK
 MONTHLY
o
INSPECT PULL BELT AND DRIVE ROLLER TRANSMISSION FOR
BAD BEARINGS, AND WORN OR LOOSE BELTS
o
CHECK OIL LEVEL IN THE GEAR BOX (FILM DRIVE AND JAW)
o
CHECK FOR BROKEN SPRINGS ON VERTICAL HEATER, FILM
SPLICER, BRAKE TENSIONER, ETC
 6 MONTHS
o
REBUILD ROTARY ACTUATOR ON VERTICAL HEATER
o
CHECK ALL JAW BEARINGS FOR EXCESSIVE SLACK
o
CHECK FOR A GAP BETWEEN THE NIP AND DRIVE ROLLER
ADJUST TENSIONING SPRINGS AS NEEDED
o
CHECK FOR WEAR ON BRAKE BADS
o
CHECK ALL PNEUMATIC COMPONENTS FOR LEAKS.