Pacmac 2015 - VERTICAL HEADER SEAL TROUBLESHOOTING; WEAK SEALS DUE TO PRESSURE LOSS; WEAK SEALS DUE TO HEAT LOSS

2015OPERATIONSMANUAL

42

LONG BAGS PRINTED FILM.
POSSIBLE CAUSES
 MISSED EYE MARK
o CHECK THAT EYE IS CENTERED OVER THE EYE MARK ON THE
FILM.
o CHECK THAT THE EYE IS SEEING THE EYE MARK AS IT PASSES
THROUGH.
o RETEACH THE EYE BY HOLDING THE BUTTON ON THE SIDE OF
THE EYE FOR 3 SECONDS OVER THE FILM BACKGROUND
AND 3 SECONDS OVER THE EYE MARK.
 PRINTED SET UP NOT COMPLETED
o WHEN CHANGING FROM ONE FILM TO THE NEXT, PRINTED
SETUP MUST BE RUN TO UPDATE THE BAG LENGTH.
o REFER TO THE 2015PM UL WIRING DIAGRAMS TO CHECK
WIRING.
TROUBLESHOOTING VERTICAL HEADER SEAL
WEAK SEALS
POSSIBLE CAUSES
 LOSS OF PRESSURE
o CHECK THE CONDITION OF THE SPRINGS ON THE
HEADER HEATER BAR.
o ENSURE THAT THE ACTUATOR IS ADJUSTED PROPERLY
AND IS COMPLETELY LOCKED OVER WHEN THE
ACTUATOR IS IN THE CLOSED POSITION.
o ENSURE THAT THE BARS ARE HITTING SQUARE. THE
ADJUSTMENT BOLTS ARE ON THE FRONT OF THE HEATER
BAR STRAP.
 LOSS OF HEAT
o CHECK HEAT SETTING ON THE TEMPERATURE
CONTROLLER.
o CHECK HEAT ROD.
o CHECK THERMOCOUPLE.
o CHECK HEATER CIRCUIT.