Pacmac 2015 - ULTRASONIC TROUBLESHOOTING; ULTRASONIC SMASH AND SHAPE ISSUES

2015OPERATIONSMANUAL

44

TROUBLESHOOTING ULTRASONICS
 NO SMASH
o SET ULTRASONICS GAP TO .010.
o ENSURE CYLINDER IS WORKING PROPERLY.
o CHECK ULTRASONICS TIMING.
o ENSURE ULTRASONICS POWER SUPPLY IS TURNED ON.
o REFER TO THE 2015PM UL WIRING DIAGRAM AND
CHECK WIRING.
 TEAR DROP SHAPE
o SQUARE UP THE HORN AND ANVIL.
REFER TO PAGE 51 FOR MORE INFORMATION ON
ULTRASONIC ADJUSTMENTS.