9.3 Adjust the log stop
9. Lock the conveyor with the lock, the chain, and the safety pin.
9.3 Adjust the log stop
The log-stop can be set in the range 25-55 cm. The log-stop is equipped with two break
bolts. Bolt size is M 8x100, sub-thread, strength class 8.8, nut m8 Nyloc.
Important: The break bolts protect the log-stop structure from damage that may occur
when an over length tree enters the splitting chute and is pushed upwards by the pusher
to a vertical position against the log-stop.
Attention: Always fasten the nut on the log-stop plate side.
©
TP SILVA 2023
Version 1.1
28 / 70 Palax C750.2
ORIGINAL INSTRUCTIONS
To Next Page
