10.2 Alternative power sources
2. Disengage the PTO shaft.
3. Loosen the stuck log.
Tip: Use another log to knock the stuck one loose.
4. Inspect the saw blade and make sure there are no cracks at the roots of the teeth.
Electric motor powered
1. Stop the machine by using the emergency stop button or the power off switch.
2. Loosen the stuck log.
Tip: Use another log to knock the stuck one loose.
3. Inspect the saw blade and make sure there are no cracks at the roots of the teeth.
10.1.7 Stuck log - cylinder out of power
If the cylinder runs out of power and a tree gets stuck,
1. Use manual control to reverse the cylinder.
2. Lift up the splitting wedge.
3. Retry splitting with the manual control.
If the tree does not split, open the protective guard and use a log to knock the stuck
tree loose.
10.2 Alternative power sources
Attention: Always remove the power take-off shaft before using electric motor
as the power source.
The machine is equipped with two power source modes, PTO as the power source or
electric motor as the power source.
The machine is equipped with a dual use prevention system.
©
TP SILVA 2023
Version 1.1
33 / 70 Palax C750.2
ORIGINAL INSTRUCTIONS
To Next Page
