14.5 Lubricate the machine
Lubricate the locking head
You can spray lubricating oil to the moving parts of the locking head through the small
hole in the middle of the end plate. Use a spray bottle with a nozzle tube.
1. Remove the cap screw on the end plate.
2. Insert the nozzle tube of the spray bottle into the hole and press for one second.
Repeat this 2 to 3 times. The oil will spread evenly onto the moving parts of the
locking head.
Lubricate the spool extension
There is a joint pin and a ball joint on the spool extension.
1. Lift up the edge of the protective rubber on the spool extension.
2. Spray oil on both sides of the pin and onto the ball joint.
3. Check that the protective rubber is intact.
14.5 Lubricate the machine
Use vaseline to lubricate the nipples on the bearings.
1. Lubricate the nipple on the multipurpose shaft.
2. Lubricate both nipples on the bearings on the multipurpose shaft.
©
TP SILVA 2023
Version 1.1
52 / 70 Palax C750.2
ORIGINAL INSTRUCTIONS
To Next Page
