14.16 Replace the infeed conveyor belt
3. Make sure that the conveyor belt runs in the middle of the roller. If necessary, adjust
the screw at the blade end of the conveyor belt so that the belt runs straight.
14.16 Replace the infeed conveyor belt
Important: Only use a conveyor belt obtained from an authorized manufacturer.
1. Disconnect the hydraulic motor hoses.
2. Protect the hose connections to prevent contamination of the motor and hoses.
3. Loosen the tightening screws of the belt
©
TP SILVA 2023
Version 1.1
65 / 70 Palax C750.2
ORIGINAL INSTRUCTIONS
To Next Page
