What to do if the electric motor of my Palax C750.2 makes loud noise but does not start?
If the electric motor of your Palax Log Splitter is making a loud noise but not starting, the fuse might be blown. Replace the fuse to resolve this issue.
Why does the saw blade on my Palax C750.2 cut heavily and heat up?
If the saw blade of your Palax Log Splitter cuts heavily and heats up, it could be due to a dull blade or too much resin. Try to sharpen the saw blade, and clean it thoroughly.
Why does the electric motor of my Palax C750.2 stop easily and the thermal relay trips?
If the electric motor of your Palax Log Splitter stops easily and the thermal relay trips, the saw blade may be dull. Sharpen the saw blade. Also, the thermal relay may not be set correctly. Contact the electric motor manufacturer.
Why does the saw blade on my Palax C750.2 Log Splitter wobble?
If the saw blade on your Palax Log Splitter wobbles, it could be due to several reasons: 1. Impurities between the flanges: Clean the saw blade and the flanges. 2. Tension faults or a dull blade: Sharpen and tension the saw blade. 3. Faulty circular saw blade operation: Do not use the machine before replacing the saw blade.
Why does my Palax C750.2 make whining sounds during splitting?
If you hear whining sounds during splitting and the revolution decreases on your Palax Log Splitter, the V-belts may be loose or worn. Tighten or change the V-belts.
Why does the saw blade on my Palax C750.2 whine?
If the saw blade of your Palax Log Splitter whines, it could be due to the motor running too fast (PTO Max. 450 r.p.m.). Reduce speed. It may also be caused by a fracture in the root of the saw blade. In this case, do not use the machine before replacing the saw blade.
What to do if the splitting cylinder on my Palax C750.2 Log Splitter does not move backwards?
If the splitting cylinder on your Palax Log Splitter does not move backwards, there may be impurities in the splitting cylinder. Clean the machine to resolve this.
Why is the saw blade on my Palax Log Splitter rotating in the wrong direction?
If the saw blade on your Palax Log Splitter rotates in the wrong direction, this is due to an incorrect phase sequence. Use a cord with a phase switch and adjust the phase sequence.
Why does the saw blade on my Palax C750.2 Log Splitter not lower?
If the saw blade on your Palax Log Splitter does not lower, check if the protective guard of the splitting chute is open. Close the guard to allow the saw blade to lower.
Why can't I launch splitting manually on my Palax C750.2 Log Splitter?
If splitting cannot be launched manually on your Palax Log Splitter, it may be because the protective guard of the splitting chute is open. Close the protective guard.
General| Brand | Palax |
|---|---|
| Model | C750.2 |
| Category | Log Splitter |
| Language | English |
To Next Page
