Palax C750.2 - User Manual

70 pages

Save Page as PDF

To Next Page

Main Page

Table of Contents2
Warranty5
EU Declaration of Conformity7
Introduction8
Intended Use8
Operating Conditions8
Ambient Conditions of Use9
Safety9
Signal Words and Symbols9
Safety Symbols Used in this Manual10
Product Information Symbols11
Safety Risks13
Noise Emission and Vibration13
Technical Data14
Product Identification (Nameplates)14
Main Dimensions15
Main Parts Ergo16
Main Parts Pro/Pro17
Operating Controls Pro / Pro18
Transport Information18
Delivery Acceptance Inspection19
Unpacking19
Lifting19
Assembly20
Set the Conveyor in Operating Position20
Set the Conveyor in Transport Position25
Adjust the Log Stop28
Operation30
General31
Crooked Trees31
Big Trees31
Small Trees Without Splitting31
Re-Splitting31
Trees with Large Branches32
Stuck Log - Faulty Cutting32
Stuck Log - Cylinder out of Power33
Alternative Power Sources33
PTO Powered34
Emergency Stop34
Cold Start35
Electric Motor Powered35
Rotation Direction Check36
Start the Motor36
Emergency Stop37
Cold Conditions37
Electric Heater (for Oil Tank)38
Circular Saw Blade Operation38
Before the Circular Saw Blade Operation38
During the Circular Saw Blade Operation39
Cut to Equal Length (Ergo)39
Operation on the Last Log40
Fully Hydraulic Control (Palax Pro & Palax Pro+)41
Safety Device42
Joystick42
Circular Saw Blade Feed Rate Valve (Pro, Pro+)43
Lever for Splitting44
Manual Lever for Splitting44
Mechanical Control (Palax C750 Ergo)46
Safety Device46
Multifunction Lever47
Install the Multifunction Lever48
Adjustment Lever for Splitting Wedge49
Maintenance Instructions49
Clean the Machine51
Clean, Tighten, and Lubricate the Conveyor Chain51
Change Hydraulic Oil51
Lubricate the Valve51
Lubricate the Locking Head52
Lubricate the Spool Extension52
Lubricate the Machine52
Lubricate the Main and Blade Shaft Bearings53
Change Oil in the Angular Gear53
Remove and Replace the Circular Saw Blade54
Tighten the V-Belts, Angular Gear/Centre Shaft57
Replace the V-Belts, Angular Gear/Centre Shaft58
Tighten the V-Belts, Centre Shaft/Blade Shaft59
Replace the V-Belts, Centre Shaft/Blade Shaft63
Sharpen the Circular Saw Blade, Hard-Metal64
Tension the Circular Saw Blade, Hard-Metal64
Tighten the Infeed Conveyor Belt64
Replace the Infeed Conveyor Belt65
Rotation Direction of the Infeed Conveyor Belt66
Clean the Conveyor66
Troubleshooting66
Storage68
Accessories68
Automatic High-Speed Valve68
Splitting Wedges68
Splitting Cylinder69
Log Table or Stand69
PALAX Manuals & Feedback69

Other manuals for Palax C750.2

Instruction Manual34 pages

Questions and Answers

K
Kenneth LoveSep 12, 2025
Why does the protective guard on my Palax C750.2 Log Splitter not open?
- K
  Kevin AdamsSep 13, 2025
  If the protective guard on your Palax Log Splitter does not open, it may be because the saw blade is not in its upper position. For PALAX C750 Ergo: Push the multifunction lever to the far right. For PALAX C750 Pro, Pro+: Start the machine and lift the saw blade with joystick valve.