10.4 Electric motor powered
1. Push the emergency lever upwards so that the lever locks, leaving the V-belts loose.
2. Switch off the PTO shaft transmission from the tractor.
10.3.2 Cold start
Run the machine in sub-zero temperatures (°C) for about 5 minutes at low (¼)
revolutions to allow the oil to warm up.
Important: This will greatly reduce wear on the hydraulics and prevent damage.
10.4 Electric motor powered
• The power output of the electric motor is 12.6 kW and the speed is 1480 rpm.
• The machine is equipped with an automatic Y - D starter with emergency stop.
• All the required electric installations are installed.
• The cross-section of the extension cord required for 380V must be minimum 6 mm
2
and fuse size must be minimum 25A.
• The motor and the starter are located under the protective covers.
©
TP SILVA 2023
Version 1.1
35 / 70 Palax C750.2
ORIGINAL INSTRUCTIONS
To Next Page
