143
Box-type, Universal
or Reversible Unit:
To check the oil level:
Lower the tail lift so that the platform touches the ground.
If required, retract all stabilizer feet.
Remove the cover from the unit.
Using the indicator at the oil reservoir or the dip stick, check
whether the indication is within the prescribed marked
range.
If required, refill oil up to level mark.
Re-install the cover of the unit.
Checking the Bolts and Nuts for Tight Seat
Check whether all bolts and nuts are seated tightly.
Especially observe all bearing pins and associated bolts
and all fastening elements of the auxiliary frame and the tail
lift mounting!
Retighten any loose bolts and nut.
Checking the Screw fittings and Pipes of the
Hydraulic System
Check all screw fittings and pipes of the hydraulic system.
Make sure that the screws are tight and the hydraulic lines
undamaged.
Retighten any loose screws.
Replace damaged hydraulic hoses immediately.
Replace all hydraulic hoses after three years at the latest.
The manufacture date is stamped on the fittings.
Checking the Bellows
Make sure that the two bellows are in a good condition and
undamaged and that they are tightly fit to the piston rod and
cylinder.
Replace damaged bellows immediately.
Betriebsanleitung_Hubladebuehnen_EN.book Seite 143 Donnerstag, 15. August 2019 4:04 16
To Next Page
Loading...
Need help?
General
