ENGLISH
- 66 (E) -
11.
Component Output Setting
[Signal Select: RGB, Y/Pr/Pb, Y/C]
This enables RGB, Y/Pr/Pb or Y/C to be selected as
the component signals which are to be output from
the I/F REMOTE connector.
12.
Digital Extender Setting
[Digital Extender: OFF, ON]
OFF: Under normal circumstances, this setting is
used.
ON: An extender effect which is approximately
1.5 times greater is achieved.
However, the resolution drops when the digital
extender is set to “ON”.
13.
Fan Setting [Fan: OFF, Auto]
(models AW-E750, AW-E655)
OFF: Select this setting to stop the fan when its
operating sound is found to be bothersome in a
studio or other such environment.
Auto: The temperature is detected automatically, and
the fan starts operating when the temperature
exceeds approx. 10 °C in the storage mode or
approx. 35 °C in any other mode.
Under normal circumstances, the “Auto” setting is
used.
14.
Auto Focus Setting [Auto Focus: OFF, ON]
(model AW-E655)
This enables auto focus ON and OFF to be controlled
when the zoom/focus cable of a Canon AF lens has
been connected to the ZOOM/FOCUS connector on
the AW-E655.
15.
Filter Setting
[Filter: IR Through, Normal, 1/16ND, 1/64ND]
IR Through: The infrared shooting mode is
established. Irradiate the subject with infrared
light.
Normal: Under normal circumstances, this setting is
used.
1/16ND: The 1/16 ND filter is inserted. Use this
setting when the lens cannot be stopped down
enough by the diaphragm.
1/64ND: The 1/64 ND filter is inserted. Use this
setting when the lens cannot be stopped down
enough by the diaphragm even at the 1/16ND
setting.
To Next Page
Loading...
