EasyManua.ls Logo

Panasonic CF-S10 Series - Reinstalling

Panasonic CF-S10 Series
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
82
Troubleshooting
Troubleshooting
Reinstalling Software
Reinstalling
CAUTION
Do not interrupt the reinstallation procedure
before completion, for example by turning off
the computer, as this may prevent Windows from
starting up, or may cause data to be lost so that
the reinstallation procedure cannot be executed.
1
Back up important data to a
location other than the hard disk
(an external hard disk or other
media).
When reinstallation procedure is performed,
the contents of the hard disk will be erased.
If you have created partitions for data, the
data may be erased or become corrupt
as a result of an unexpected malfunction,
incorrect operation, or other reason.
2
Make a note of the networks
settings.
When reinstallation procedure is performed,
the network’s settings will be erased.
3
Make a note of your user name
and password.
When reinstallation procedure is performed,
your user name and Windows password will be
erased.
4
Turn off the computer, and
connect the AC adaptor.
5
Turn on the computer, and press
or while [Panasonic]
boot screen is displayed to start
up the Setup Utility.
F2
Press
Press
or
Del
If the [Panasonic] boot screen is not
displayed, turn on the computer while
holding down
or . Hold down
or until the Setup Utility screen or
password input screen appears.
When the password is set, [Enter Password]
will be displayed. Enter supervisor
password, and press
.
Enter Password
You cannot set default settings (except the
password, System Time and System Date)
with a User Password.
If you change the settings from that at the
time of purchase, we recommend that
you make a note of the settings that are
changed.
6
Press .
F9
Press
7
At the confirmation message,
select [Yes] and press .
Load Optimized Defaults
Load Optimized Defaults?
Yes No
8
Press , and then select [Yes]
at the confirmation message and
press .
The Setup Utility will close, and the computer
will restart.
If the password has been set, enter the
Supervisor Password, and press
.
DFQW5600ZABasicManualCF-S10.indb82DFQW5600ZABasicManualCF-S10.indb82 2011/11/1514:08:462011/11/1514:08:46

Table of Contents

Related product manuals