PREPARATION BEFORE OPERATION
7
Close the front panel
■ Notes
• If the unit is not going to be used for an extended period of time, turn off the Power switch. If it is left at the ON
position, approximately 2.5 W of electricity will be used even if the main unit has been turned off with the remote
control.
• If operation is stopped, then restart immediately, the unit will resume operation only after 3 minutes.
● Indoor Unit
1 Connect the power
supply cord to an
independent power
supply
POWER SLEEP TIMER
ECONOMY
POWERFUL
6
Switch on the power switch
ON
x
t
OFF
3 Remove the air filters
2 Open the front panel
5
Insert the air filters
4
Insert the air purifying filters
Use under the following conditions
(Unit in °C)
Outdoor
DBT
32
16
WBT
23
11
Indoor
DBT
43
16
WBT
26
11
Outdoor
DBT
30
16
WBT
_
_
Indoor
DBT
24
-5
WBT
18
-6
Cooling Heating
DBT: Dry Bulb Temp
WBT:Wet Bulb Temp
Maximum Temperature
Minimum Temperature
! Warning
■ Ensure the power plug is securely inserted.
A loose plug may cause a fire or an electric shock.
To Next Page
Loading...
Need help?
General
