Panasonic CS-PC12TKF

34
6 Bind all the indoor and outdoor connection cable with tape and route the connection cable via the right
escapement.
7 Remove the tapes and connect the power supply cord and connection cable between indoor unit and outdoor
unit according to the diagram below.
2
1
ti
n
u
r
o
o
d
t
u
o
eh
t n
o
sl
a
nimr
e
T
Colour of wires (connection cable)
Terminals on the indoor unit
LN12
(Power supply cord)
Terminals on the isolating devices
(Disconnecting means)
(L) (N)
8 Secure the power supply cord and connection cable onto the control board with the holder.
9 Close grille door by tighten with screw and close the front panel.
Terminal
Board
Control
Board
Earth wire
longer than
others
AC wires
for safety
reason
Holder
Holder
Connection cable
Indoor & outdoor
connection cable
Isolating Devices Outdoor unit
Power supply
cord
Power supply cord
Recommended
length (mm)
Tape
Recommended
length (mm)
abcde f
55 35 35 50 40 60
Tape
WARNING
This equipment must be properly earthed.
Note:
 Isolating Devices (Disconnecting means) should have minimum 3.0 mm contact gap.
 Ensure the colour of wires of outdoor unit and the terminal Nos. are the same to the indoor’s respectively.
 Earth wire shall be Yellow/Green (Y/G) in colour and longer than the other AC wires as shown in the figure for the
electrical safety in case of the slipping out of the cord from the anchorage.