Call Hold Key Telephone Features
3-16 DBS 824-3.0/3.2-700 Revised April 2000
• The phone issues intercom dial tone.
• “Hold TRK #XX” (where “XX” is the outside line number) appears on the
display.
To release a call placed on System Hold from the extension that
placed it there:
Press the line key that is flashing green.
• The line LED stops flashing and remains lit.
• “CO TALK #XX” (where “XX” is the outside line number) appears on the
display.
To release a call placed on System Trunk Hold from a different
extension:
Press the line key that is flashing red.
• The line LED turns green and stops flashing.
• “CO TALK TRK #XX” (where “XX” is the outside line number) appears
on the display.
Related Programming
• FF1 (System): Attendant Hold Recall Timer for CO Calls
• FF1 (System): Attendant Hold Recall Timer for Intercom Calls
• FF1 (System): Extension Hold Recall Timer for CO Calls
• FF1 (System): Extension Hold Recall Timer for Intercom Calls
• FF1 (System): Key Bank Hold
• FF1 (System): Non-Appearing Trunk Hold
Considerations
• When using an outside line for which there is no line key on your
extension, press the
HOLD
key to place the call on hold and then press a
vacant line key. Release the held call by pressing
HOLD
again. (System
programming determines whether the call will be placed on Exclusive
Trunk Hold or System Trunk Hold.)
To Next Page