Panasonic DBS 824 - Page 175

Absence Message DSLT Features
4-4 DBS 824-3.0/3.2-700 Revised April 2000
Operation
To Set an Absence Message
1. Lift the handset or press
ON/OFF
.
2. Dial “71.”
3. Enter a message code between 0 and 9 (See Table 4-1).
4. Enter the time you will return (optional). See Table 4-2 for examples.
5. Replace the handset or press
ON/OFF
.
To Cancel an Absence Message
1. Lift the handset or press
ON/OFF
.
2. Dial “71.”
3. Replace the handset or press
ON/OFF
.
Related Programming
• FF1 (System) Extension Class of Service Setting
• FF3 (Extension) Extension Class of Service Assignment
• FF6 (Names and Messages): Absence Messages
Considerations
• Extensions without displays get a busy signal, rather than the Absence
Message.
• If an extension user selects a message code number 5-9 that has not been
set up with a message, “Absence,” followed by the code number, appears
on the caller’s display.
• Absence Message return times can be entered as shown in Table 4-2:
6 User Defined
7 User Defined
8 User Defined
9 User Defined