DSLT Features Call WaitingCall
Revised April 2000 DBS 824-3.0/3.2-700 4-17
Table 4-4. Call Waiting Text Messages
Message codes 0-4 cannot be used.
Operation
To Set Call Waiting:
1. Lift the handset.
2. Dial the extension number.
3. Upon hearing busy tone, press “3.”
4. If you wish to send a text message, dial the desired message code (5-7 or
9).
The message appears on the called party’s phone if the called party has a
display phone. (If the extension does not have a display, it will continue to
issue a call waiting tone.)
5. Remain on the line until the called party picks up.
To answer Call Waiting (after disconnecting the current call):
1. Replace the handset.
The current call is disconnected.
2. Pick up the handset.
You are automatically connected to the extension sending the Call
Waiting.
To answer Call Waiting (without disconnecting the current call):
1. Press
HOLD
.
• The current call is disconnected.
Message
Code
Message
5“Visitor Here”
6 “Need Help”
7 “Important”
9 “Emergency”
To Next Page
Loading...
