Appendix A 2.0 Features Update
Revised April 2000 DBS 824-3.0/3.2-700 A-9
assigned to display in FF3 ExtPort# 28#. The same applies when the
extension receives CO dial tone (FF3 ExtPort# 29#); during a trunk
call (FF3 ExtPort# 30#); and after dialing a busy extension (FF3
ExtPort# 33#).
• Use existing addresses FF1 2# 7# 1# thru 4# to assign select key
features to Flexible Function Screens.
• Select key features for Fixed Function Screens will not appear on
small-display phones.
3. While the select key feature is displayed, you can execute the feature
by pressing the > or < select key.
Notes
Toggling Variable Mode On/Off with an FF-Key.
You can program the
*61
code
into an FF-key: In programming mode, press FF5 (ExtPort)# (KeyNo.)# (*61)#.
The FF-key will toggle Variable Mode on/off while the extension is idle or in an
off-hook/dial-tone state. The FF-key LED will remain lit (red) while Variable
Mode is “On”. (You can also use a one-touch key to toggle Variable Mode on and
off; however, one-touch keys do not contain an LED to indicate when Variable
Mode is on.)
Variable Mode After Power-Cycling.
If Variable Mode is “On”, the extension
will stay in Variable Mode even after power-cycling (system is powered down,
then powered back up).
Incompatibility with older phone versions.
Variable Mode is available on the
44-Series phones only.
Conditions under which Variable Mode does not work.
Variable Mode will be
temporarily overridden under the following conditions: during an incoming
message state, hold state, message-waiting state, or call-waiting state. Incoming
messages include:
CO Queuing
Incoming [trunk no.]
REV.[extension no.]
TRF.[trunk no.]
H-Recall
Call Wait
REC.[trunk no.]
Recall Hnt [Hunt Group no.]
DISA Incoming
Call [extension no.]
Transf [extension no.]
Recall [trunk no.]
HOLD Recall
To Next Page
Loading...
