Recording Television Programmes
Refer to “Important Notes for Recording” (➔ 17) and “Advanced Recording” (➔ 18 to 20) for detail information on
recording.
RAM
-R
-R DL
-RW(V)
+R
+R DL
+RW
Preparation:
• Turn on the television and select the appropriate video input to suit the
connections to this unit.
•
RAM
If the disc is protected, release protection (➔ 44).
to turn the unit on.
to open the tray (Button located on front of the unit).
Insert a disc with enough remaining blank space and press
[; OPEN/CLOSE] again to close the tray.
When the format confirmation screen is displayed (➔ 19)
–
–
to select desired channel.
To select with the numbered buttons (➔ 12)
When no channel setting is performed on the unit and broadcast is
recorded directly from the satellite receiver, select a channel on the
connected equipment and press [INPUT SELECT] to select “AV2”.
–
–
to select the recording mode.
Recording mode (➔ 18)
Remaining time
to start recording.
Elapsed recording time
Pausing Recording
Press [h PAUSE].
– Press again to restart recording.
(The title is not divided.)
Stopping Recording
Press [g STOP].
Tips
Icons such as “
RAM
” indicate usable
discs. Refer to pages 58 and 59.
-RW(V)
+R
+R DL
+RW
To use a new disc, formatting is necessary.
Notes
-R
-R DL
-RW(V)
+R
+R DL
+RW
It takes about 30 seconds for the unit
to complete recording management
information after recording finishes.
You cannot change the channel or
recording mode during recording.
This unit cannot record onto discs on
which you recorded with a different
encoding system from the TV system set
on this unit. Change “TV System” in the
Setup menu.
•
•
•
•
•
To Next Page
Loading...
Need help?
General
